- LENGTH: 239 MM
- WIDTH: 193 MM
- MAXIMUM HEIGHT: 331 MM STACKABLE: 316 MM
- WEIGHT (BODY + CAP): 390/400 g ± 10 g DIN 45: 11 g
- NOMINAL CAPACITY: 10 LITERS
- MAXIMUM CAPACITY: 10.7 LITERS
SPECIFICATIONS
Recommended for packaging chemicals, oils, detergents, solvents, various liquids, etc. The virgin material (HDPE) is certified for contact with food.
Upon customer request, the containers can be manufactured in various other weights.
The canisters are supplied with self-sealing caps in two versions:
– SK 45/26 MAB, blue/red/black;
– DIN 55, black.
The full cans are stacked in three overlapping rows.
The products are packaged in plastic bags, 12 pieces per bag.
The surface of the canister must be smooth, free of cracks, fissures, holes, weak spots, burrs,
impurities, and distortions.
The canisters must be stored in covered storage areas, at least 1 m away from sources of active heating
, at temperatures up to 40 °C and not lower than 0 °C.
Avoid direct exposure to UV rays.
After filling, the canisters must be stacked on pallets with a flat surface, ensuring that the canister
has adequate support at all points where it touches the ground, thereby ensuring an even distribution of
static and dynamic load forces. Failure to meet these conditions may result in
excessive load on one side or corner of the canister and, consequently, an uneven distribution of
the load on the pallet.
The maximum number of canisters in storage after filling must be determined by taking the following factors into
:
– liquid density;
– liquid temperature and ambient temperature;
– storage conditions after filling (distance, pallet, etc.)
– transport conditions after filling (distance, type, and mode of transport) and the forces developed
during static and dynamic transport, as well as other factors not mentioned.
Choosing the wrong packaging after filling may result in damage to the canister and
cause it to lose its seal.
The manufacturer's liability is limited solely to the defective product and does not cover the consequences
resulting from improper handling of the product; therefore, the manufacturer's instructions
must be followed.
It is the customer’s responsibility to inspect and test our products to ensure
that they meet the customer’s specific requirements.
The recipient is also responsible for the proper processing and handling of our products in a safe and legal manner
; CARMATROX INDUSTRIE TOP is not responsible for
notifying you of any changes in legislation.
Given that the products supplied by CARMATROX INDUSTRIE TOP are used in conjunction with
third-party materials, it is the recipient’s responsibility to obtain all necessary information
regarding the third-party materials and to ensure that CARMATROX INDUSTRIE TOP products, when
used with other materials, are suitable for the recipient’s specific purposes. We
assume no responsibility for the use of CARMATROX INDUSTRIE TOP products in combination
with other materials. The information contained herein applies exclusively to our products when
they are used in combination with other materials.
The canisters are 100% recyclable. They can also be reused within a circular collection and
reuse system, with the number of reuses depending on the type of contents, the packaging method,
storage, and transportation. The number of reuses is determined by each individual user. Exceptions
to the recycling/reuse rules include containers used to package products made from
The category of dangerous goods for which containers cannot be cleaned or disinfected and must be incinerated
.
With our ADR certification, we confirm that we are prepared to safely handle and transport dangerous goods in accordance with UN standards. It is a testament to our commitment to safety and compliance with regulations in the road transport industry.